Equipment
Hardware compatibility
Scratch Like This is designed to work with compatible hardware in three categories on macOS and Windows: DJ controllers, DVS systems and motorized platters. This page explains how each type connects and what you need. The models listed are examples we've used in development and testing. They aren't a complete list of supported hardware.
Scratch Like This runs on its own. It reads your controller or timecode directly, so you don't need Serato, Traktor, rekordbox or any other DJ software running while you practice. If another DJ app is open, it may already be using your controller or audio interface, so close it before you start.
- Tested
- Tested and working in our development builds
- In testing
- Works, final testing before launch
DJ Controllers
Scratch on the jog wheel and cut with the crossfader, the same way you would in a set.
How it connects
- USB, using MIDI
- Controllers with a built-in preset work as soon as you plug them in.
- For other controllers, you assign the jog wheel, crossfader and play/cue buttons in the app: press Learn, then move or press that control. You then calibrate the jog wheel with one full turn.
What you need
- A controller that sends MIDI messages for jog wheel movement and the crossfader. A jog touch sensor is used if your controller has one.
- The manufacturer's driver, if your controller needs one on your computer.
DVS Systems
Scratch on real turntables or a DVS controller with timecode. The app listens to the timecode signal and turns it into record movement.
How it connects
- Timecode audio through an audio interface, or a mixer with a built-in sound card
- You choose the input channels in the app, then calibrate the signal (left/right balance and phase), as you would in other DVS software.
What you need
- A turntable with control vinyl, or a timecode device such as MWM Phase
- An audio interface or mixer that gives your computer a stereo input for each deck
- Supported timecode: Serato (1 kHz) and Traktor (2 kHz). With Traktor timecode, the app follows the record's speed and direction, but not yet its needle position.
Motorized Platters
Controllers with a spinning platter feel like a turntable: the record keeps turning under your hand, and the app follows it.
How it connects
- USB, using MIDI
- Controllers with a built-in preset are set up automatically, including their own motor. For others, you assign the platter and crossfader with Learn, as with DJ controllers.
What you need
- A motorized controller that sends platter movement as MIDI messages
- The manufacturer's driver, if your controller needs one on your computer
Compatibility may vary depending on your hardware configuration, drivers and available control signals. If you are unsure about your setup, contact support@scratchlikethis.com.
Tell us what you scratch on
When you join early access, you can tell us your setup. It helps us choose which hardware to test next.
Join Early AccessProduct names are trademarks of their respective owners. Scratch Like This isn't affiliated with or endorsed by them.
← Back to Scratch Like This
